I've not used their WOL app, it might not use a pinhole. The app might be easier to use once working, but this will work. Get one working on the computer you are controlling and it will work. You should be able to log into a computer remotely and trigger a WOL program on the LAN. In case Wake on Lan to be done using Teamviewer remotely, not within the network, it requires port forwarding in its configuration and the static IP address. You won't be able to wake that computer if it's where all your WOL packets originate. The computer on your LAN with teamviewer needs to be available in order to send WOL packets over your network. Your "server" already opens a connection to teamviewer's corporate server which lets your clients in outside your NAT. Teamviewer's company brokers the connection to your LAN so you aren't forwarding ports. Try turning PC on (must be in sleep/hibernate to work on most PC's, unless you have already seen it work locally being totally powered off)ĭoes your teamviewer not work remotely? Teamviewer shouldn't need port forwarding. You want to forward port 9 to your IP address in step 2 over UDP, save that.Ĥ) install TV on your phone, connect via LTE (not wifi) to test. check by opening command prompt and type "ipconfig /all" (no quotes) it will tell you your IP and whether you're using DHCP or not (it will show disabled if you have a static address configured).ģ) Log into your d-link device and go to port forwarding. Either way, these two devices need to be on the same subnet (e.g your ISP box shouldnt be a 192.168.0.1 while the Dlink is a 192.168.1.1)ġ) Go the the options, configure Wake on LAN, select public address and put your public static IP in there (google "what is my IP"), leave the port on 9Ģ) Assuming you already have a static address in your PC's IPv4 settings, if not you need to set one. ![]() You really dont want two routers in a setup like this, why do you have the d-link at all if the ISP provided box acts as a router as well? Are you sure there isnt a third box from the ISP? (else Ill assume the ZXHN is modem/router combo). ![]() For example, if the client address is 192.168.1.12, the broadcast address used in the packet would be 192.168.1.255.This is tested and works for me, using TeamViewer 13 It may be necessary to change the address to broadcast the packet to the whole network.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |